The Cisco perimeter switch must be configured to suppress Router Advertisements on all external IPv6-enabled interfaces.

Many of the known attacks in stateless autoconfiguration are defined in RFC 3756 were present in IPv4 ARP attacks. To mitigate these vulnerabilities, links that have no hosts connected such as the interface connecting to external gateways must be configured to suppress router advertisements.

This requirement is not applicable for the DODIN Backbone.

Review the switch configuration to verify that Router Advertisements are suppressed on all external IPv6-enabled interfaces as shown in the example below.

interface gigabitethernet1/0 ipv6 address 2001::1:0:22/64 ipv6 nd ra suppress

If the switch is not configured to suppress Router Advertisements on all external IPv6-enabled interfaces, this is a finding.

Configure the switch to suppress Router Advertisements on all external IPv6-enabled interfaces as shown in the example below.

SW1(config)#int g1/0 SW1(config-if)#ipv6 nd ra suppress SW1(config-if)#end