The Cisco ISE must perform continuous detection and tracking of endpoint devices attached to the network. This is required for compliance with C2C Step 1.

Continuous scanning capabilities on the Cisco ISE provide visibility of devices that are connected to the switch ports. The Cisco ISE continuously scans networks and monitors the activity of managed and unmanaged devices, which can be personally owned or rogue endpoints. Because many of today's small devices do not include agents, an agentless discovery is often combined to cover more types of equipment.

If DOD is not at C2C Step 1 or higher, this is not a finding.

If not required by the NAC SSP, this is not a finding.

Review the posture settings to verify the Continuous Monitoring Interval is enabled and a value is configured.

From the Web Admin portal: 1. Choose Work Centers >> Posture >> Settings >> Posture General Settings. 2. Verify that "Continuous Monitoring Interval" is enabled and an interval is configured.

Note: For versions after version 3.1, it may be necessary to navigate to Administration >> System >> Settings >> Posture >> General Settings to access this setting.

If "Continuous Monitoring Interval" is not enabled with an interval defined, this is a finding.

If required by the NAC SSP, configure the posture settings to enable the Continuous Monitoring Interval.

From the Web Admin portal: 1. Choose Work Centers >> Posture >> Settings >> Posture General Settings. 2. Check "Continuous Monitoring Interval" and define an interval to enable continuous monitoring. 3. Choose "Save".

Note: For versions after version 3.1, it may be necessary to navigate to Administration >> System >> Settings >> Posture >> General Settings to access this setting.