Forescout must be configured to notify the user before proceeding with remediation of the user's endpoint device when automated remediation is used. This is required for compliance with C2C Step 3.

Connections that bypass established security controls should be allowed only in cases of administrative need. These procedures and use cases must be approved by the information system security manager (ISSM).

Unless an exception is approved to not require notification of the user, the following configurations must be implemented: - This setting may be sent from the assessment server, a central server, or from the remediation server. - Verify the user is notified and accepts (e.g., using an accept button) that remediation is needed and is about to begin.

If DoW is not at C2C Step 3 or higher, this is not a finding.

Check Forescout policy to verify that exempt devices in need of remediation prompt the user to accept the remediation process, prior to conducting. 1. Log on to the Forescout UI. 2. Select the "Policy" tab. 3. Review the compliance policy identified by the site representation as the remediation policy, then click "Edit". 4. In the Sub-Rules section, select a policy and click "Edit". 5. From the Actions section, verify that the policy is configured to notify the user prior to remediation.

If Forescout is not configured to notify the user before proceeding with remediation of the user's endpoint device when automated remediation is used, this is a finding.

Log on to the Forescout UI.

1. Select the "Policy" tab. 2. Select a compliance policy, then click "Edit". 3. In the Sub-Rules section, select a policy and click "Edit". 4. From the Actions section, click Add >> Notify >> and select a notification method.