SUSE operating systems with Unified Extensible Firmware Interface (UEFI) implemented must require authentication upon booting into single-user mode and maintenance.

If the system allows a user to boot into single-user or maintenance mode without authentication, any user that invokes single-user or maintenance mode is granted privileged access to all system information.

If the system is running in EFI mode, SLES 12 by default will use GRUB 2 EFI as the boot loader.

Verify that the SUSE operating system has set an encrypted boot password.

Note: If the system does not use Unified Extensible Firmware Interface (UEFI) this requirement is Not Applicable.

Check that the encrypted password is set for a boot user with the following command:

# sudo cat /boot/efi/EFI/sles/grub.cfg | grep -i password 

password_pbkdf2 boot grub.pbkdf2.sha512.10000.VeryLongString

If the boot user password entry does not begin with "password_pbkdf2", this is a finding.

Note: If the system does not use UEFI, this requirement is Not Applicable.

Configure the SUSE operating system to encrypt the boot password.

Generate an encrypted (GRUB 2) password for a boot user with the following command:

# sudo grub2-mkpasswd-pbkdf2 Enter Password: Reenter Password: PBKDF2 hash of your password is grub.pbkdf2.sha512.10000.MFU48934NJD84NF8NSD39993JDHF84NG

Using the hash from the output, modify the "/etc/grub.d/40_custom" file with the following command to add a boot password for the root entry:

# cat << EOF set superusers="boot" password_pbkdf2 boot grub.pbkdf2.sha512.VeryLongString EOF

Generate an updated "grub.conf" file with the new password using the following commands:

# sudo grub2-mkconfig --output=/tmp/grub2.cfg
# sudo mv /tmp/grub2.cfg /boot/efi/EFI/sles/grub.cfg